Air and water LPG heater Belief

Air and water LPG heater is a warm-air heater with integrated hot water boiler. This unit was designed for installation in motorhomes and caravans. t.

Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest
INQUIRY

Air and water LPG heater Belief

Air and water LPG heater is a warm-air heater with integrated hot water boiler. This unit was designed for installation in motorhomes and caravans. This heater is a combination of hot water and warm air, which can provide hot water for life while heating the compartment. It is allowed to be used during driving. This heater can also use city electricity to start.
we also have water parking heater, electric car parking heater, and 2018 new air and water integrated heater.

1.Introduction

Air and water LPG heater is a warm-air heater with integrated hot water boiler. This unit was designed for installation in motorhomes and caravans.

2.Working Principle

This heater is a combination of hot water and warm air, which can provide hot water for life while heating the compartment.It is allowed to be used during driving.This heater can also uses city electricity to start.

3.Technical Specifications :

Rated voltage DC12V 12V/24V
Max power consumption 5.6A
Average power consumption 1.3A
Thermal power(W) 2000 4000 6000
Fuel consumption g/h 160 320 480
LPG pressure bar 30mbar
Warm air supply m3/h 287max
Water tank capacity 10L
Max water pump pressure 2.8bar
Max system pressure 4.5bar
City electric voltage ~230V
City electric power (W) 900 Diesel 1800
City electric power consumption 3.9A 7.8A
Working(environment)temperature -25℃~+80℃
Working height above sea level ≤1500m
Net Weight (Only heater) 15.6
Dimensions (mm) 510×450×300

4.Application:

This heater can both heat hot water and compartment of motorhomes and caravans. It must not be installed in buses (vehicle classes M2 and M3) or in vehicles for transporting hazardous goods. It has additional electric heating elements for operation with a mains voltage of 230 V~


5.Advantages:

Only one heater for both vehicle heating and hot water supply

1. All-purpose: It can be operated with fuel or diesel, electricity or in hybrid mode;
2. Convenience: Automatic temperature control can be realized in conjunction with A/C;
3. High efficiency: self-sufficiency and low energy consumption;
The scope of application The integrated heater has high power and high heat efficiency.
It is suitable for the supply of hot water and warm air for self-propelled motorhome and trailer motorhome.


6.About us

Our factory was established in April 1998, located in Harbin, Heilongjiang province.
We have the independent R&D organization and has established long-term cooperative relationships with state key universities and colleges like Harbin Institute of Technology, Harbin Engineering University, etc.
Annual production is more than 150,000 sets.
\

Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest
No. Name Specifications Amount
1 Parking heater 5KW 1
2 Timer 1
3 Fuel pump YB-Ⅰ-12V(24V) 1
4 Muffler XYQ-Ⅰ 1
5 Wiring harness 1
6 Water pump 12V (24V) 1
7 Heater bracket 1
8 Rubber cushion 4
9 Muffler bracket 1
10 Air inlet pipe Φ20.5/Φ24 L=900 1
11 Exhaust pipe Φ24/Φ29.5 L=1000 1
12 Positive wire of power supply 1
13 Fuse base With cover 1
14 Fuse QY169-5A 1
15 Fuse 12V/20A(24V/15A) 1
16 Fuse QY169-25A 1
17 Water pipe Φ17/Φ27 L=2600 1
18 Clip 16-25 1
19 Spring clip Φ24×Φ27 10
20 Oil pump clip Φ32 1
21 Oil pipe clip 8-10 (9-11) 12
22 Exhaust pipe clip Φ24-28 3
23 Air inlet pipe fixing clip Φ24 t=0.5 2
24 Exhaust pipe fixing clip Φ27 t=0.8 2
25 Fuel pipe GasolineΦ1.5×Φ4(DieselΦ2×Φ5) 1
26 Fuel pipe connector Φ3.5/Φ9.5(Φ4.1/Φ10.5) 6
27 water pipe connector Φ18 L=55 2
28 Special water pipe connector PPA +33 Φ20×Φ18  L=60 2
29 Relay 4141(only for 12V) 1
30 Filter RYL-Ⅰ(only for diesel) 1
31 Bolt M6×10 1
32 Self drilling tapping screw ST5.5×25 6
33 Self drilling tapping screw ST5.5×30 5
34 Self tapping screw ST3×20 1
35 Self tapping screw ST4×16  3
36 Spring washer Φ6  2
37  Washer Φ6/Φ12  2
38 Nut M6  1
39  Fuel suction pipe XYG-Ⅰ 3×400  1
40 Plug DJ7041A-2.8-21 1
41  Nylon cable ties 4×150 1
42  Nylon cable ties 4×200 1
43 Instruction manual 1
44 Reducing T Φ6-Φ10/Φ10  1
45  Oil pipe clip 12-14  2
46  Non-return valve D18 1
47 Transition elbow  2
48  Fixing gear  2
49 O-ring 14.8×2.62  2
50 Bolt M6×95  4
Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest

Your Name :

Your Email:

Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest